Severely Damaged BRAND NEW Ferrari

December 4, 2018

"My car is brand new, it doesn't need anything!" 

 

 

     This is understandably common to hear in the detailing industry.  Unfortunately it's often far from the truth.  Vehicles directly from the factory commonly have surface finish issues such as dust in the paint, "fish eye" clear-coat defects, sanding mark, etc.  There are also potential problems during shipment where the car can be damaged in transit, as well as vehicles that often sit on a shipping dock being covered in railway dust and/or salt water for extended periods of time.   When the car is finally delivered to the dealer, some of the most common damage we see is micro-marring or "swirl marks" caused by being washed and dried by an untrained dealer lot technician  

 

 

 

 

 

This Ferrari 488 had some of the worst of each of these we've ever seen.  Check out some of the errors in the finish of this BRAND NEW (80 mile odometer) Ferrari.

 

 

 

 Compound burn on the rubber trim 

(This is caused by a technician at the factory "burning" the rubber trim with a polisher)

 

 

 

 

 

 

 

 

Lots of swirl marks and scratching throughout the paint

 

 

 

 

Water spot etching and swirl marks

 

 

 

 

 

Compound residue on bumper near the headlamp

 

 

 

 

Compound residue on lug nuts!

 

 

 

 

 

These small "squiggly lines" around the spot light reflection are actually deep scratches in the finish from sand paper that was used at the factory to level a piece of dirt or dust in the paint.  The technician didn't properly polish his sanding marks and sent the car down the line without being finished.

 

 

 

 

 

Compound residue on the air intake

 

 

 

 

Compound residue in the headlight washer

 

 

 

Severe sanding marks and swirls

 

 

 

Swirls in the black top (BEFORE)

 

 

 

Swirls in the black top (AFTER)

 

 

 

 

 

Swirl marks and compound residue on the finish and burned into the rubber trim of the corner light 

 

 

 

This is a DEEP scratch in the door.  We were able to minimize it, but it was actually so deep it was too risky to polish down far enough to completely fix it.

 

 

Not only are there severe sanding marks in the paint, but the parking sensor trim is burned and stained from the technician at the factory compounding the area without finishing his polish job (BEFORE)

 

 

 

 

 

(AFTER)

 

 

The intakes are very tricky to access and polish.  We had to use our wireless 1" polisher.

 

 

 

 

The "Ferrari" emblem is removed from the rear deck lid to properly polish the area.  New hardware is purchased and used to reattach it.  (BEFORE)

 

 

 

 

 

(AFTER)

 

 

 

Burned trim.

 

 

 

 

 

Deep scratch on the rear-view-mirror

 

 

 

More compound in the panel gaps

 

 

 

Deep scratch on tail light

 

 

 

 

 

The paint actually had black dots of overspray from paint in the engine bay!

 

 

 

 

The front parking sensor also had severe burning as well.

 

 

 

Compound dust stuck in the air intakes

 

 

 

 

 

 

The factory clear protection film is already peeling at the top edge and has compound stuck in the edge

 

 

 

 

Two days was spent performing a full Paint Correction service to remedy

the errors in the finish 

 

 

 

The wheels had some strange adhesive staining on the inner hubs.  This required aggressive polishing to fully remove.

 

 

 

 

 

 

 

 

(AFTER)

 

 

 

 

Lug nuts were polished before being reinstalled

 

 

 

 

Wheel-wells were cleaned as well

 

 

Brake Calipers were covered in a Ceramic Coating to add protection and

easy maintenance cleaning


 

 

 

 

The entire car was then covered in our two-part Ceramic Coating to add a ton of gloss, protection and make it easier to clean the car in the future.  

 

 

 

 

 

The end result was a deep, glossy finish with years of protection and easy maintenance 

 

 

 

 

 

 

 

 

This video shows the Ceramic Coating in action:

 

 

 

Although the damage was severe, we were able to completely remedy it, add significant gloss and protection with the Ceramic Coating, and give this customer the perfect car that they deserved!

 

 

 

If you enjoyed this article or got any value from it, feel free to click the link below to leave us a positive review or follow us for more updates:

 

 

 

 

 

 

Share on Facebook
Share on Twitter
Please reload